Product Description

Design standards: API 600、GB/T 12234
DN: 2 "-48", DN50-DN800
PN: Class150-Class1500
Body material: carbon steel, stainless steel, alloy etc.
Operation: manual, gear, motor etc.

The trim of wedge gate valve is wedge, which is vertical to medium flow direction. Gate valve can only be fully open/close, and can not be used as adjusting valve. Wedge gate valve can be a unique type called inflexible disc; and can also be a flexible wedge
Gate valve under low pressure occasion, disc is forced to set to guarantee sealing; while disc is forced to contact another seat by high pressure condition. There is a slot structure inside the cavity to make sure the disc will not rotate under pressure, and also guarantee there is no friction before close position between seat and disc, thus reduces frictions on sealing face

Wedge gate valve has following advantages
1Small flow resistance, sealing face suffers less flush and corrosion.
2 Low torque operation, easy operation
3 Direction of medium is not limited, not generate disturbed flow, and not reduce medium pressure.
4 Simple structure, short face-to-face dimension, process precisely and widely applicable

Wedge gate valve of BONSF has following advantages
1. Product fabrication is strictly according to API 600, full port design, on full open position, valve disc is higher that flow direction to guarantee flow smoothly, reduce pressure loss, high transmission efficiency.
2. For carbon material valve, seat is forged, high density, good sealing capacity. Sealing face use 13Cr or Stellite hard alloy material, overlay net thickness is over 2mm, valve seat is threaded or welded on the valve body, easy to maintain and dissemble.
3. Adopt rising stem, stem and disc is connected by a T shaped groove, T head and stem is forged together to guarantee enough connection strength. Flexible disc structure can avoid stuck caused by heat inflation
4. Back seal design will protect packing when valve is fully opened. Packing is flexible graphite, good sealing capacity, and also venting system is available. Packing bush and gland are ball structure, pressure process will enable the stem to automatically centralized, avoid stem stuck.
5. Bolted bonnet structure and thick hex nut fastening parts will ensure reliable function. Gasket adopt flexible graphite twist stainless steel or octagonal ring to get good sealing effect
6. Top entry nut design assures that, when the valve is open, even if demount the hand-wheel, stem and disc will not fall down. Stem is made by Aluminum bronze, and both sides set bearing, all this made the valve easy to operate.

No download information!!